KitchenAid · Washer Serious

F7E1 — Motor Speed Sensor Fault

The motor control board cannot achieve correct drum speed. The motor or tachometer is reporting incorrect RPM during agitation or spin.

Keep using it?
Limited use only
DIY difficulty
Hard
Verified against
kitchenaid.com ↗

How to fix it

  1. Redistribute or remove load and restart
  2. Unplug washer for 1 minute
  3. Try cycle with light load to isolate balance issues
  4. Inspect drive belt and tub spin freely by hand
  5. Test motor windings with multimeter
  6. Replace motor or MCU if testing confirms failure

Why it happens

Typical signs: F7E1 displayed · No agitation or spin · Drum doesn't turn · Burnt smell from motor area

  • Overloaded or unbalanced drum Too much laundry preventing rotation
  • Defective drive motor Motor windings or bearings failed
  • Failed motor control unit (MCU) Inverter board not driving motor correctly
  • Loose drive belt (if equipped) Belt slipping or off pulley
  • Seized tub bearing Bearing prevents drum from spinning freely

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

More KitchenAid washer codes

F0E1 F0E1 — Load Detected During Clean Washer Cycle F1E1 F1E1 — Main Control Board Failure F2E1 F2E1 — Stuck Button on User Interface F3E1 F3E1 — Pressure Switch Failure F5E1 F5E1 — Lid Switch Fault F5E2 F5E2 — Lid Lock Will Not Lock

All KitchenAid codes → All washer codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: kitchenaid.com.