KitchenAid · Washer Serious

F8E1 — No Water Detected / Long Fill

The washer is not filling within the expected time. The control did not see water level rise after opening the inlet valves.

Keep using it?
Limited use only
DIY difficulty
Easy
Verified against
kitchenaid.com ↗

How to fix it

  1. Verify both hot and cold supply valves are fully open
  2. Disconnect fill hoses and clean inlet screens
  3. Straighten any kinks in fill hoses
  4. Confirm strong water flow at supply line
  5. Test inlet valve solenoids for continuity
  6. Replace water inlet valve if defective

Why it happens

Typical signs: F8E1 displayed (often shown as LF/LO FL) · Washer doesn't fill or fills very slowly · Cycle hangs at fill

  • Water supply valves closed Hot/cold faucets at wall not fully open
  • Clogged inlet hose screens Sediment screens at valve inlet blocked
  • Kinked fill hose Hose pinched behind washer
  • Faulty water inlet valve Valve solenoid not opening
  • Low household water pressure Pressure below 20 psi required

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

More KitchenAid washer codes

F0E1 F0E1 — Load Detected During Clean Washer Cycle F1E1 F1E1 — Main Control Board Failure F2E1 F2E1 — Stuck Button on User Interface F3E1 F3E1 — Pressure Switch Failure F5E1 F5E1 — Lid Switch Fault F5E2 F5E2 — Lid Lock Will Not Lock

All KitchenAid codes → All washer codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: kitchenaid.com.