KitchenAid · Washer Moderate

F8E2 — Dispenser Fault

The detergent/bleach/softener dispenser motor is not driving to the correct position, or dispenser flow is blocked.

Keep using it?
Yes, with caution
DIY difficulty
Easy
Verified against
kitchenaid.com ↗

How to fix it

  1. Remove dispenser drawer and clean thoroughly with warm water
  2. Clear any residue from drawer housing and nozzles
  3. Reinstall drawer and restart cycle
  4. If error persists, access dispenser motor and test
  5. Replace dispenser motor assembly if failed

Why it happens

Typical signs: F8E2 displayed · Detergent not dispensing · Dispenser drawer stuck · Cycle pauses at dispense step

  • Clogged dispenser drawer Hardened detergent or buildup blocking flow
  • Defective dispenser motor Stepper motor for dispenser failed
  • Blocked dispenser nozzles Spray nozzles inside top panel clogged

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

More KitchenAid washer codes

F0E1 F0E1 — Load Detected During Clean Washer Cycle F1E1 F1E1 — Main Control Board Failure F2E1 F2E1 — Stuck Button on User Interface F3E1 F3E1 — Pressure Switch Failure F5E1 F5E1 — Lid Switch Fault F5E2 F5E2 — Lid Lock Will Not Lock

All KitchenAid codes → All washer codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: kitchenaid.com.