KitchenAid · Washer Moderate

Lo FL — Low Flow / Low Water Pressure

The washer detects water entering but at insufficient flow rate to fill within expected time.

Keep using it?
Yes, with caution
DIY difficulty
Easy
Verified against
kitchenaid.com ↗

How to fix it

  1. Open both water supply valves fully
  2. Test water pressure at the supply line (need 20-100 psi)
  3. Clean inlet screens at the back of the washer
  4. Avoid running washer during heavy household water use
  5. Replace clogged or partial-flow valves

Why it happens

Typical signs: Lo FL or LF displayed · Slow fill · Cycle takes longer than usual · Eventually triggers F8E1

  • Low household water pressure Below 20 psi minimum
  • Partially closed supply valves Faucets not fully open
  • Clogged inlet screens Sediment restricting flow
  • Shared water demand Other fixtures running simultaneously

More KitchenAid washer codes

F0E1 F0E1 — Load Detected During Clean Washer Cycle F1E1 F1E1 — Main Control Board Failure F2E1 F2E1 — Stuck Button on User Interface F3E1 F3E1 — Pressure Switch Failure F5E1 F5E1 — Lid Switch Fault F5E2 F5E2 — Lid Lock Will Not Lock

All KitchenAid codes → All washer codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: kitchenaid.com.