GE · Washer Moderate

E22 — Fill Timeout (No Fill / Slow Fill)

The washer did not reach its target water level within the allowed fill time. This is a FILL fault — a water-supply, valve, or inlet-screen issue — not a drain fault.

Keep using it?
Yes, with caution
DIY difficulty
Moderate

How to fix it

  1. Confirm both hot and cold water supply valves behind the washer are fully open.
  2. Unplug the washer, then disconnect the fill hoses at the back of the machine.
  3. Remove and clean the small mesh inlet screens at the valve ports — sediment buildup is the most common cause.
  4. Check the fill hoses for kinks or crushing and replace if damaged.
  5. Reconnect everything, restore power, and run a cycle to confirm normal fill flow.
  6. If flow is still slow or absent with clean screens and open valves, test the water inlet valve for continuity and replace it if it won't open.

Why it happens

Typical signs: Cycle stalls or pauses during the fill portion · E22 flashes on display · Little or no water entering the tub, or filling much slower than normal · Water valves hum but produce weak flow

  • Water supply valve(s) closed or barely open Check both the hot and cold shutoff valves behind the washer — some cycles need both open even for a cold-fill wash.
  • Clogged inlet screens The small mesh filters where the fill hoses connect to the washer's valve ports get clogged with sediment over time — the most common cause.
  • Kinked or crushed fill hose Check the hoses behind the machine for pinches or damage.
  • Low household water pressure Weak supply pressure can cause the fill to time out even with everything else working.
  • Failed water inlet valve The solenoid valve isn't opening electrically even when commanded.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • GE washer water inlet valve Common replacement
    Amazon →
  • Washer fill hose set Common replacement
    Amazon →

More GE washer codes

dE dE — Lid Is Open E23 Drain Pump Error — Will Not Drain E31 E31 — Drain Timeout E42 E42 — Drive Motor Instantaneous Overcurrent E43 E43 — DC Fault, Inverter E54 E54 — No Motor Response / Lost Communication with Drive Motor

All GE codes → All washer codes →

Frequently asked questions

What does the E22 code mean on a GE washer?

The washer did not reach its target water level within the allowed fill time. This is a FILL fault — a water-supply, valve, or inlet-screen issue — not a drain fault.

What causes the E22 code on a GE washer?

Water supply valve(s) closed or barely open: Check both the hot and cold shutoff valves behind the washer — some cycles need both open even for a cold-fill wash. Clogged inlet screens: The small mesh filters where the fill hoses connect to the washer's valve ports get clogged with sediment over time — the most common cause. Kinked or crushed fill hose: Check the hoses behind the machine for pinches or damage.

Is it safe to keep using a GE washer with a E22 error?

Yes, with caution. This is rated a moderate-severity fault.

How do I fix E22 on a GE washer?

Confirm both hot and cold water supply valves behind the washer are fully open. Unplug the washer, then disconnect the fill hoses at the back of the machine. Remove and clean the small mesh inlet screens at the valve ports — sediment buildup is the most common cause.

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician.