GE · Washer Moderate
FILL — Slow or No Fill
Washer didn't reach the target water level within the allowed time. Almost always a water-supply issue, not a washer fault.
- Keep using it?
- Yes, with caution
- DIY difficulty
- Easy
- Verified against
- geappliances.com ↗
How to fix it
- Confirm both hot and cold supply valves are fully open.
- Shut off water, disconnect hoses, and clean the inlet screens.
- Straighten any kinks in the fill hoses.
- Run a fill cycle and check both hot and cold flow.
- If one side won't fill, replace the water inlet valve.
Why it happens
Typical signs: Cycle pauses with 'FILL' lit · Very slow water flow into tub · No water entering
- Closed or partially closed supply valves Hot/cold faucets behind the washer not fully open.
- Clogged inlet screens Sediment in the small screens where hoses meet the washer.
- Kinked fill hoses Hose pinched behind the machine.
- Failed water inlet valve Solenoid won't open fully or at all.
- Low household water pressure Must be at least 10 psi; well systems often the culprit.
Parts you may need
If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.
More GE washer codes
Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: geappliances.com.