GE · Washer Moderate

tE — Temperature Sensor Fault

The NTC temperature sensor is reading out-of-range. Could be the sensor itself, its wiring, or the control board's reference circuit.

Keep using it?
Yes, with caution
DIY difficulty
Moderate
Verified against
geappliances.com ↗

How to fix it

  1. Unplug the washer.
  2. Locate the NTC at the heater or sump.
  3. Inspect the connector for moisture/corrosion and clean it.
  4. Measure NTC resistance at room temperature — typically around 5–10kΩ; compare to spec.
  5. Replace the NTC if out of range.
  6. If sensor and wiring are good, replace the main control board.

Why it happens

Typical signs: tE on display · Water temperature wrong or unregulated · Sanitize/hot cycles unavailable

  • Failed NTC thermistor Sensor open/shorted.
  • Loose or corroded sensor harness Connection at sensor or control board compromised.
  • Water leaking onto sensor connector Slow boot/sump leak corroding the connector pins.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • GE washer temperature sensor Common replacement
    Amazon →

More GE washer codes

dF / dE dF / dE — Door Lock Engagement Error E22 E22 — Drain Pump / Drain Time Exceeded E23 Drain Pump Error — Will Not Drain E31 E31 — Pressure Sensor Fault E42 E42 — Door Lock Will Not Unlock E43 E43 — Door Open During Cycle

All GE codes → All washer codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: geappliances.com.