Maytag · Dryer Moderate

E1 — Thermistor Open Circuit (Generic)

On older Maytag dryers without the F-code dictionary, E1 indicates an open thermistor (exhaust or inlet, depending on model). No heat will be allowed.

Keep using it?
Yes, with caution
DIY difficulty
Moderate
Verified against
maytag.com ↗

How to fix it

  1. Unplug the dryer and locate the thermistor on the blower housing.
  2. Measure resistance — should be about 10 kΩ at room temperature.
  3. Replace the thermistor if open or far off spec.
  4. Inspect the harness end-to-end for breaks; repair as needed.
  5. Reassemble and run a heated cycle.
  6. If the code persists with a known-good thermistor and wiring, replace the control board.

Why it happens

Typical signs: E1 on display · No heat · Cycle stops early · Cool air only

  • Open thermistor Internal element failed open.
  • Disconnected sensor wire Push-on connector slipped.
  • Cut harness Wire damaged near blower housing.
  • Failed control board Rare board failure.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Maytag dryer thermistor Common replacement
    Amazon →

More Maytag dryer codes

AF AF — Airflow Restricted E2 E2 — Thermistor Shorted F01 F01 — Main Control Board Fault F02 F02 — Keypad / User Interface Stuck Key F22 F22 — Outlet Thermistor Fault F23 F23 — Exhaust Thermistor Shorted

All Maytag codes → All dryer codes →

Frequently asked questions

What does the E1 code mean on a Maytag dryer?

On older Maytag dryers without the F-code dictionary, E1 indicates an open thermistor (exhaust or inlet, depending on model). No heat will be allowed.

What causes the E1 code on a Maytag dryer?

Open thermistor: Internal element failed open. Disconnected sensor wire: Push-on connector slipped. Cut harness: Wire damaged near blower housing.

Is it safe to keep using a Maytag dryer with a E1 error?

Yes, with caution. This is rated a moderate-severity fault.

How do I fix E1 on a Maytag dryer?

Unplug the dryer and locate the thermistor on the blower housing. Measure resistance — should be about 10 kΩ at room temperature. Replace the thermistor if open or far off spec.

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: maytag.com.