Maytag · Dryer Moderate

E2 — Thermistor Shorted

The thermistor circuit reads as shorted (very low resistance). The control disables heat for safety.

Keep using it?
Yes, with caution
DIY difficulty
Moderate
Verified against
maytag.com ↗

How to fix it

  1. Unplug the dryer.
  2. Disconnect the thermistor and measure resistance — a near-zero reading means a shorted sensor.
  3. Replace thermistor if shorted.
  4. If thermistor reads correctly, inspect the harness for damage where wires pass through metal panels.
  5. Repair any damaged insulation with proper splices and loom.
  6. Test with a heated cycle to confirm.

Why it happens

Typical signs: E2 on display · No heat · Cycle terminates early · Drum still turns

  • Shorted thermistor Internal failure shorting the element.
  • Pinched wire grounded to chassis Wire chafed against sheet metal.
  • Water/condensation across sensor terminals From damp environment or leak.
  • Failed control board input Rare.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Maytag dryer thermistor Common replacement
    Amazon →

More Maytag dryer codes

AF AF — Airflow Restricted E1 E1 — Thermistor Open Circuit (Generic) F01 F01 — Main Control Board Fault F02 F02 — Keypad / User Interface Stuck Key F22 F22 — Outlet Thermistor Fault F23 F23 — Exhaust Thermistor Shorted

All Maytag codes → All dryer codes →

Frequently asked questions

What does the E2 code mean on a Maytag dryer?

The thermistor circuit reads as shorted (very low resistance). The control disables heat for safety.

What causes the E2 code on a Maytag dryer?

Shorted thermistor: Internal failure shorting the element. Pinched wire grounded to chassis: Wire chafed against sheet metal. Water/condensation across sensor terminals: From damp environment or leak.

Is it safe to keep using a Maytag dryer with a E2 error?

Yes, with caution. This is rated a moderate-severity fault.

How do I fix E2 on a Maytag dryer?

Unplug the dryer. Disconnect the thermistor and measure resistance — a near-zero reading means a shorted sensor. Replace thermistor if shorted.

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: maytag.com.