Maytag · Dryer Moderate

F24 — Inlet Thermistor Fault

The inlet thermistor (near the heat source) is reading out of range — open, shorted, or drifted. Temperature control is compromised.

Keep using it?
Yes, with caution
DIY difficulty
Moderate

How to fix it

  1. Unplug the dryer and access the heater assembly (typically requires removing the back panel on electric models or the front/toe panel on gas).
  2. Locate the inlet thermistor near the heater inlet.
  3. Measure resistance and compare against the tech sheet (around 10 kΩ at 77°F).
  4. Replace if out of spec or open.
  5. Inspect and clean the lint screen housing and vent — overheat events are usually airflow related.
  6. Reassemble and run a heated cycle to verify the fault clears.

Why it happens

Typical signs: F24 on display · No heat or weak heat · Dryer stops early · Long dry times

  • Failed inlet thermistor Component drift or failure.
  • Wiring fault to inlet thermistor Pinched, chafed, or loose connection.
  • Damaged by overheat event Restricted airflow caused thermistor damage.
  • ACU input circuit failure Rare board-level fault.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Maytag dryer inlet thermistor Common replacement
    Amazon →

More Maytag dryer codes

AF AF — Airflow Restricted E1 E1 — Thermistor Open Circuit (Generic) E2 E2 — Thermistor Shorted F01 F01 — Main Control Board Fault F02 F02 — Keypad / User Interface Stuck Key F22 F22 — Outlet Thermistor Fault

All Maytag codes → All dryer codes →

Frequently asked questions

What does the F24 code mean on a Maytag dryer?

The inlet thermistor (near the heat source) is reading out of range — open, shorted, or drifted. Temperature control is compromised.

What causes the F24 code on a Maytag dryer?

Failed inlet thermistor: Component drift or failure. Wiring fault to inlet thermistor: Pinched, chafed, or loose connection. Damaged by overheat event: Restricted airflow caused thermistor damage.

Is it safe to keep using a Maytag dryer with a F24 error?

Yes, with caution. This is rated a moderate-severity fault.

How do I fix F24 on a Maytag dryer?

Unplug the dryer and access the heater assembly (typically requires removing the back panel on electric models or the front/toe panel on gas). Locate the inlet thermistor near the heater inlet. Measure resistance and compare against the tech sheet (around 10 kΩ at 77°F).

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician.